Lucent DDM-2000 OC-3 User And Service Manual page 941

363-206-285
Issue 2, February 2000
16. To gain more familiarity with MS-DOS, floppy disks handling, making backup
copies of the original and new generic programs, refer to DLP-533 and
DLP-534.
17. NOTE:
Local operating procedures must be established to use a PC and a hard
disk containing the necessary program files. You can copy all files on the
source diskette(s) to a directory on the hard disk and load the generic
from that directory.
Start MS-DOS operating system on the PC.
Response:
!
18.
CAUTION:
It is important to NOT mix IMA LAN generic files with the NE generic files
in the same directory; the files for each generic type must be copied to a
separate directory on the hard disk drive.
If you are going to use the PC hard disk to load software to the shelf, copy all
files on the source floppy disks (containing the IMA LAN files) to a directory on
the hard disk. Then use the cd command to change to the appropriate hard
drive directory containing the software.
19. If you are going to load the software from floppy disks, use the appropriate
MS-DOS command (i.e., a: or b:) to go to the drive with the floppy disk
installed.
Response:
Comment:
20. NOTE:
The IMA LAN generic program may be on more than one floppy disk.
The PC will prompt you to insert disks as needed after the first disk is
installed.
If you are using floppy disks, insert the first (number 1) disk into the PC drive
(if not using the hard drive).
PC displays the prompt (C>,
determined by the PC.
PC displays the appropriate prompt (A>,
C:DOS>, etc. . . .).
If you get a disk error message, verify the drive latch is
locked and that you have the proper diskette installed in
the drive.
DDM-2000 OC-3 M
Detailed Level Procedure:
C:/DOS.
ULTIPLEXER
DLP-528
Page 5 of 12
etc.)
B>, C>,