Lucent DDM-2000 OC-3 User And Service Manual page 547

NTP-057
: System Turnup
Page 5 of 12
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
11.
NOTE:
If Sync Autoreconfiguration is enabled, Kbyte/Sbyte must
also be enabled.
NOTE:
If Sync Autoreconfiguration is enabled at any line-timed
OC-3/OC-12 node in a ring, it must be enabled at all
line-timed OC-3/OC-12 nodes of a ring.
NOTE:
The rtrv-sync: command retrieves the
Synchronization
provisioning and operational information on the
synchronization attributes of the DDM-2000. See the
Commands and Reports section of this manual and the
OC-3 manual for a description of the rtrv-sync:
command format.
Use the rtrv-sync: command to obtain the
Synchronization Report and verify if Sync
Autoreconfiguration is enabled or disabled. Use the set-sync:
command to enable or disable the Sync Autoreconfiguration
parameter, as required.
12.
NOTE:
Two or more shelves in the same network cannot have the
same system name or TID (set by the set-ne: command).
Verify no duplicate TID settings exist. The rtrv-ne: command
may be used at each shelf in the network to display settings. If
duplicates exist, determine new settings and use the set-ne
command to make new settings.
Report. This report displays the
DDM-2000 OC-3 M
Issue 3, June 2001
ULTIPLEXER
363-206-285