Lucent DDM-2000 OC-3 User And Service Manual page 814

DLP-512
: Detailed Level Procedure
Page 4 of 10
set-oc3
set-oc12
set-ow
set-state-oc1
set-state-ec1
set-state-t1
set-state-t3
set-state-sts1
set-state-vt1
set-sts1
set-t1
set-t3
set-vt1
set-x25
3. Determine options required from office records.
Sets the characteristics of an OC-3 line pair. Sets the
signal degrade threshold of the OC-3 line as a bit error
rate (BER). Specifies if sync message signaling uses
kbyte or sbyte or is enabled or disabled. Specifies if
the concatenation mode (concat) of the OC-3 line is to
be independent STS-1 channels or an sts-3c channel.
Sets the characteristics of an OC-12 line pair. Sets the
signal degrade threshold of the OC-12 line as a bit
error rate (BER). Specifies if sync message signaling
uses kbyte or sbyte or is enabled or disabled.
Sets the orderwire routing for the network element.
Sets the state of OC-1 line(s) to be monitored (IS) for a
good signal or not monitored (NMON).
Sets the state of a low-speed EC-1 port to be
automatically monitored (AUTO) for a good signal or
not monitored (NMON).
Sets the state of a low-speed port to be automatically
monitored (AUTO) for a good signal or not monitored
(NMON).
Sets the state of a DS3 port to be automatically
monitored (AUTO) for a good signal or not monitored
(NMON).
Sets the state of a STS-1 channel to be automatically
monitored (AUTO) for a good signal or not monitored
(NMON).
Sets the state of a VT1.5 channel to be automatically
monitored (AUTO) for a good signal or not monitored
(NMON).
Sets the signal degrade characteristics of an STS-1
channel.
Sets the characteristics of a DS1 port.
Sets the characteristics of a DS3 port.
Sets the signal degrade characteristics of a VT1.5
channel.
Sets the packet size of X.25 link to either 128 or 256.
DDM-2000 OC-3 M
Issue 2, February 2000
ULTIPLEXER
363-206-285