Lucent DDM-2000 OC-3 User And Service Manual page 676

363-206-285
Issue 2, February 2000
4. Connect the CIT to the CIT connector on the near-end User Panel and log in to
the near-end system, if not already performed.
Reference: DLP-521
5.
NOTE:
The rtrv-alm: command can be used to display a report of active
alarm and status conditions. The Commands and Reports section of this
manual gives a description of the command.
NOTE:
The Active Alarm and Status Report is output automatically
following CIT log in. The report shown in Figure 1 is an example that
shows several entries. There may be only one entry in the actual report.
Note the information in the Source Address and Description columns for
the top entry/entries above the first single-dashed line in the Active Alarm
and Status Report (Figure 1) (for example,
abnormal a-1-1 MM-DD HH:MM:SS nsa DS1 loopback).
/* Active Alarms and Status Report
=============================================================
Alarm Source
Level Address
=============================================================
abnormal a-1-1
-------------------------------------------------------------
*/
Figure 1 – Example of Active Alarms and Status Report
Date Time
Detected
MM-DD HH:MM:SS
DDM-2000 OC-3 M
Trouble Clearing:
Srv Description
nsa DS1 loopback
ULTIPLEXER
TAP-109
Page 2 of 4