Lucent DDM-2000 OC-3 User And Service Manual page 121

363-206-285
Issue 2, February 2000
DO ITEMS BELOW IN ORDER LISTED . . . . .FOR DETAILS, GO TO
NOTE:
The following commands may be used to convert, delete,
enter, and retrieve STS-1 cross-connections:
dlt-crs-sts1, ent-crs-sts1, and rtrv-crs-sts1.
See the Commands and Reports section of this manual for a
description of commands. See Cross-Connection
Provisioning in the Administration and Provisioning section
of this manual for more information on cross-connection
provisioning.
Determine the necessary STS-1 cross-connections for each node
from the work order or circuit order.
8. Make necessary STS-1 cross-connections for each node in the
network.
A. Ring Configuration
B. Dual Ring Interworking (DRI) Configuration
C. Single/Dual OC-3/OC-48 Configuration
D. Single/Dual OC-3/OC-12 Configuration
9.
NOTE:
For a DS3 circuit in a path protected ring network, the
sw-path-sts1:address command must be used at the
terminating nodes [and dual ring interworking (DRI) nodes in
a DRI ring network] to switch the active STS-1 (DS3) path to
repeat this test on the other path.
Perform DS3 end-to-end transmission test for each circuit being
put into service (optional).
A. Single Ring Configuration
B. Dual Ring Interworking (DRI) Configuration
C. Single/Dual Homing Configuration
10. Use the set-t3: command to set the characteristics of the DS3
port.
11. Use the rtrv-state-eqpt: command to determine the port
state of the DS3 port(s) of the circuit being established.
DDM-2000 OC-3 M
Circuit Order:
ULTIPLEXER
NTP-007
Page 3 of 4
DLP-546
DLP-550
DLP-559
DLP-560
DLP-511
DLP-553
DLP-511