Lucent DDM-2000 OC-3 User And Service Manual page 813

363-206-285
Issue 2, February 2000
set-pmthres-vt1
set-secu
set-sync
Other optional features are set from the CIT but are not lost if the SYSCTL is
replaced.
!
CAUTION:
Execution of these commands may be service affecting.
These features may be found under the following listings:
ent-crs-sts1
ent-crs-sts3c
ent-crs-vt1
set-ec1
set-feat
set-oc1
Sets the thresholds of the VT1.5 path performance
parameters. Also enables or disables the processing
of the threshold crossings for these performance
parameters.
Sets security on each CIT port and DCC interface.
Enabling security requires users to enter login and
password to access the system.
Sets synchronization mode switching to revertive or
nonrevertive. After the end-to-end system is
established, sets synchronization source to select the
line from which shelf loop-timing and/or the DS1 sync
output will be derived. Sets output mode to select the
source of the DS1 sync output.
Specifies STS-1 cross-connect routing. Used in
establishing service and/or performing transmission
tests.
Specifies STS-3c cross-connect routing. Used in
establishing service and/or performing transmission
tests.
Specifies VT1.5 (DS1) cross-connect routing. Used in
establishing service and/or performing transmission
tests.
Sets the characteristics of an EC-1 port.
Enables feature options that are licensed for use:
sts3c, vtpm, ds1pm.
Sets the characteristics of a OC-1 line. Sets the signal
degrade threshold of the OC-1 line as a bit error rate
(BER).
DDM-2000 OC-3 M
Detailed Level Procedure:
ULTIPLEXER
DLP-512
Page 3 of 10