Lucent DDM-2000 OC-3 User And Service Manual page 661

TAP-107
: Trouble Clearing
Page 17 of 28
Table B – RTRV-ALM Message Descriptions (Continued)
Description
inc IMA Grp Abort FE
inc IMA Grp Fail Startup NE
inc IMA Grp Fail Startup FE
inc IMA Grp Insuff Links NE
inc IMA Grp Insuff Links FE
Alarm
Level
Status
Status
Status
Status
Status
DDM-2000 OC-3 M
Issue 2, February 2000
Meaning
This status message indicates that the far-end IMA
LAN circuit pack was unable to negotiate a
mutually acceptable IMA configuration with the
near-end IMA termination. The system was unable
to transition the IMA group into the operational
state. This message has the source address of an
IMA LAN port (e.g. a-1).
Likely causes: The near-end or far-end IMA
termination may need a provisioning change to
achieve mutually acceptable configuration
parameters.
This status message indicates that the near-end
IMA LAN circuit pack is stuck in the IMA Group
Startup state. This could result from a near-end
IMA LAN circuit pack failure or if the far-end IMA
LAN circuit pack does not acknowledge the
near-end's transition to the Startup State. This
message has the source address of an IMA LAN
port (e.g. a-1).
This status message indicates that the far-end IMA
LAN circuit pack is stuck in the IMA Group Startup
state. This could result from a far-end IMA LAN
circuit pack failure or if the near-end IMA LAN
circuit pack does not acknowledge the far-end's
transition to the Startup State. This message has
the source address of an IMA LAN port (e.g. a-1).
This status message indicates that the near-end
IMA LAN circuit pack has not detected sufficient
links to transition the IMA Group into the
operational mode. The IMA LAN circuit pack
requires only one good link to transition into
operational mode. This message has the source
address of an IMA LAN port (e.g. a-1).
This status message indicates that the far-end IMA
LAN circuit pack has not detected sufficient links to
transition the IMA Group into the operational mode.
The IMA LAN circuit pack requires only one good
link to transition into operational mode. This
message has the source address of an IMA LAN
port (e.g. a-1).
ULTIPLEXER
363-206-285