363-206-285
Issue 2, February 2000
15. Retrieve generic software version ID by depressing the ACO button longer
than 2 seconds and observing version code on the FE ID display. If the
software version is not the correct version, you must find circuit packs with the
correct software or install new software using the procedures of DLP-532.
NOTE:
16.
If you are using this procedure to replace a SYSCTL that was already in
service, there may have been some options set using the craft interface
terminal (CIT).
Refer to DLP-512 and set any required options.
17. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
DDM-2000 OC-3 M
Detailed Level Procedure:
ULTIPLEXER
DLP-501
Page 7 of 8