Installation Method When The Got Is Turned On - Mitsubishi Electric GT11 User Manual

16.3.1 Installation method when the GOT is turned on

The displayed message is different depending on the installation condition of Standard monitor OS. When
the screen requesting operation is displayed, operate the GOT according to the instructions on the screen.
Operation procedure
1
1
2
3
4
5
6
7
8
16.3 BootOS and Standard Monitor OS Installation Using CF Card
16.3.1 Installation method when the GOT is turned on
Power OFF GOT and CF card access
switch. Insert the CF card in which
BootOS, Standard monitor OS or project
data is stored in the CF card interface of
GOT.
Switch ON the CF card access switch of
GOT.
Power ON the GOT touching the upper and
lower left corners of the GOT screen.
BootOS and Standard monitor OS are
installed in the built-in Flash memory.
The CF card access LED is lit during
installation.
Do not pull out the CF card or power off the
GOT while the CF card access LED is lit.
GOT restarts automatically after installation
is completed.
(When Standard monitor OS is already
installed, touch the
OK
the GOT.)
After confirming that GOT restarted
normally, switch OFF the CF card access
switch of GOT.
Confirm the CF card access LED is
extinguished, remove the CF card from the
CF interface of GOT.
9
10
11
12
13
14
15
button to reboot
16
16 - 5