14.3.1 Installing when starting the GOT
The displayed message is different depending on the installation condition of standard monitor OS. When
the screen requesting operation is displayed, operate the GOT according to the instructions on the screen.
(1) Drives to be used
(2) S.MODE switch-pressing installation function
Power OFF GOT and CF card access switch. Insert the CF card in which BootOS, standard monitor OS
or project data is stored in the CF card interface of GOT.
BootOS cannot be stored in the CF card where standard monitor OS or project data is stored.
Switch ON the CF card access switch of GOT.
Power on the GOT.
Power on the GOT while pressing the installation switch (S.MODE switch) on the back of the GOT. (1-
point press installation function)
If the installation failure and the GOT malfunction occur, take the following action.
• If BootOS installation failed
14.5.1 Installing the CoreOS)
• If standard monitor OS installation failed:
14.3.1 Installing when starting the GOT)
When installing OS at power-on, use the A drive.
The B drive cannot be used for OS installation at power-on.
When the CF card that stores data with the OS boot drive set to the A drive is
used, the S.MODE switch-pressing installation function is not available.
14.3 BootOS and Standard Monitor OS Installation Using CF Card or