Siemens Hicom 150 E Office Service Manual page 549

Hicom 150 E Office Rel.1.0 Service Manual - 7.11 Networking
Subject
Feature available in
HW requirements
SW requirements
Dependencies/Limitations
Subject Dependency/Limitation
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step
1. Configure CFW with rerouting
*9531994
2. 17-17-1 => Call Management Out - Route Optimise - Optimise Route
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step
1. Configure CFW with rerouting
Options
2. Lines / networking
3. Routing parameters
Performing Feature Check
Check the feature for error-free functioning as follows:
Step
1. In an extension B in the satellite PABX, initiate CFW to an extension C in the main PABX.
2. Call extension B in the satellite PABX from an extension A in the main PABX.
3. The lines to the satellite PABX are released if possible.
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_711.htm (13 of 17) [06/04/2000 13:11:34]
OfficePro OfficeCom
x
-
As of Rel. 1.0 As of Rel. 1.0
Action
Action
OfficePoint OfficeOne
x _
- -
_
Action
_
-
_