Siemens Hicom 150 E Office Service Manual page 353

Hicom 150 E Office Rel.1.0 Service Manual - 7.12 Features for Call Detail Recording
10 77 to 87 Project code entered by the user for this call:
11 88 to 98 MSN used: mmmmmmmmmmm
12 99 to 103 Seizure code used, access code: bbbbb
13 104 to
105
14 106 bis
107
15 108
16 109 bis
112
14 106 to
107
15 108
16 109 to
112
17 113 to
114
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_712.htm (18 of 21) [06/04/2000 13:08:19]
ppppppppppp
(p = project code digit: value range 0 ... 9)
If a project code was not entered, 11 blanks are
output. If the project code is shorter than 11
positions, the remaining positions are filled
with blanks.
(m = digits for the MSN: value range 0 ... 9)
This is displayed if the subscriber has
programmed an MSN key. Digits not available
are replaced by leading blanks. If MSN
information is not available (e.g. PtP
connection), 11 blanks are output instead of
these characters.
(b = digits for seizure code: value range 0 ... 9)
Characters not available are replaced with
leading blanks.
LCR route available: rr
(r = digit of dialled route: value range 0 ... 9)
Characters not available are replaced with
leading blanks.
PRI Nodal Service: nn
(n = Ziffer: Wertebereich 0 ... 9)
Nicht vorhandene Stellen werden durch
führende Blanks ersetzt.
PRI WATS-Band: w
(w = Ziffer: Wertebereich 0 ... 9)
Liegt keine Information vor, wird ein Blank
ausgegeben.
PRI Carrier Identification Code CIC: cccc
(c = Ziffer des CIC: Wertebereich 0 ... 9)
Nicht vorhandene Stellen werden durch
führende Blanks ersetzt.
USA-specific fields are filled with blanks.
End-of-line control characters
(Carriage Return CR, Line Feed LF)
11 Left
11 Right
5 Right
2 Right
2 Rechts
1 -
4 Rechts
2 Right
1 -
4 Right
2 -