Siemens Hicom 150 E Office Service Manual page 244

Hicom 150 E Office Rel.1.0 Service Manual - 9 Terminals
Connection setup
Connection cleardown
Call acceptance
A special AT command is used to activate API2 mode from the PC, after which the adapter
transports transparent D channel messages in both directions (PC <--> Hicom 150 E Office).
9.2.2.7 optiset E data adapter
The optiset E data adapter (TA 232D) provides data communication with a PC without having to
equip the PC with an S
command sets, default settings) or V.25bis (switchover from Hayes (AT) to V.25bis takes place with
the AT%V command).
Data connection
Connection setup
Connection cleardown
Call acceptance
Voice connection
(e.g. dialling aid)
Connection setup
Connection cleardown
Call acceptance
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_9.htm (11 of 17) [06/04/2000 13:06:13]
card. The adapter supports terminal dialling according to Hayes (AT
0
Table 9-2 AT command sets for the optiset E data adapter
Command
ATDT
is also possible.
Either a data connection or a voice connection is set up,
depending on the connection type last selected.
ATH
ATA
Command
ATDP
is also possible.
Either a data connection or a voice connection is set up,
depending on the connection type last selected.
AT*H
or
AT%H
AT*A
ATD
or
ATDP
or
ATDT
or
AT*D
AT*H
or
AT%H
AT*A
Remarks
Remarks
AT*D
ATD