Individual Code Lock - Siemens Hicom 150 E Office Service Manual

Hicom 150 E Office Rel.1.0 Service Manual - 7.3 Features for general outgoing traffic
Configure the feature via Hicom Assistant T as follows:
Step
1. Configure DTMF mode
*9531994
2. 22-20 => System Options - Automatic DTMF
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Configure DTMF mode
Options
2. System Parameters
3. Flags / CMI
4. DTMF automatic
Performing Feature Check
Check the feature for error-free functioning as follows:
Step
1. Set up a call
2. If "DTMF automatic" has been set in the system, it switches to DTMF mode immediately
following connection.
If "DTMF automatic" has not been set, enter the code *53 after connection.
3. Each time a key is pressed on the dialling keypad, one DTMF digit is transmitted.

7.3.2 Individual Code Lock

Definition
After the code lock on the telephone is activated, the user cannot place outgoing external calls,
although he can continue to place internal calls. It is also still possible to forward incoming calls to
internal extensions. The code lock is activated by pressing a key or dialling a code and entering your
personal identification number (PIN), which always consists of 5 digits.
You can continue to use system speed-dialling while the code lock is active.
Model-Specific Data
Subject
Feature available in
HW requirements
SW requirements
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_73.htm (2 of 6) [06/04/2000 13:10:06]
Action
OfficePro OfficeCom
x
-
As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Action
OfficePoint
x x
- -
OfficeOne
x
-