Siemens Hicom 150 E Office Service Manual page 513

Hicom 150 E Office Rel.1.0 Service Manual - 7.7 Least Cost Routing (LCR)
Least cost routing If the type "primary carrier" is entered in the outdial rule, routing does not take
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step
1. Configure LCR
*9531994
2. 35-1 => Least Cost Routing - Least Cost Routing on / off
3. 35-2 => Least Cost Routing - Dial Control
4. 35-3 => Least Cost Routing - Outdial rule
5. 35-4 => Least Cost Routing - PIN Number
6. 35-5 => Least Cost Routing - LCR Schedule
7. 35-6 => Least Cost Routing - Restriction
8. 35-7 => Least Cost Routing - Routing tables
9. 35-8 => Least Cost Routing - Dialing plan
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Configure LCR
Options
2. Least cost routing
Performing Feature Check
Check the feature for error-free functioning as follows:
Step
1. Configure LCR.
2. Make an outgoing call.
3. The call will be routed as per setting.
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_77.htm (7 of 8) [06/04/2000 13:10:56]
place in the path tables.
If rerouting is to be performed in the case of "busy" or faulty S
should be set to "Single-Stage".
Action
Action
lines, the type
0