Collect Protection Per Co Line - Siemens Hicom 150 E Office Service Manual

Hicom 150 E Office Rel.1.0 Service Manual - 7.5 Features for Incoming external traffic
2. Trunk modules
3. Announcement equipment
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1.
2.
3.

7.5.11 Collect protection per CO Line

Definition
This feature enables incoming reverse charge calls to be released automatically. Each analog trunk
(loop start) can be configured individually. If the feature has been released for an analog trunk, 1 s
(default value) after an incoming call has been answered, the loop is opened for 2 s (default value).
This enables reverse charge calls to be released in the network, other calls are not affected by this.
Model-Specific Data
Subject
Feature available in
HW requirements
SW requirements
Dependencies/Limitations
Subject
Collect protection per CO line Only available in Brazil. The setting is ignored in all other countries.
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_75.htm (17 of 18) [06/04/2000 13:10:28]
OfficePro OfficeCom OfficePoint OfficeOne
x
analog
trunk line
(loop start)
As of Rel. 1.0
Action
- -
- -
- -
Dependency/Limitation
-
-
-