Intercept Conditions - Siemens Hicom 150 E Office Service Manual

Hicom 150 E Office Rel.1.0 Service Manual - 7.5 Features for Incoming external traffic
6. 34 -3 => DISA - End-of-dialling criterion
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Enter DISA authorisation
Options
2. Set up station
3. Station
4. Param
5. Flags
6. Configure DISA
Options
7. System Parameters
8. System settings
Performing Feature Check
Check the feature for error-free functioning as follows:
Step
1. Configure DISA.
2. Dial DISA number using DID.
3. Using the DISA procedure, activate call forwarding in an extension.
4. Call forwarding is activated for this extension.

7.5.8 Intercept Conditions

Definition
The intercept feature is used to forward incoming calls to another destination. The call is intercepted if
the original destination is invalid or if limitations exist.
The following intercept destinations can be entered:
PC - AC
Station
Hunt group
Announcement (external announcement device)
If an intercept position / AC has been configured in the system, in the event of an intercept the calls
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_75.htm (11 of 18) [06/04/2000 13:10:28]
Action