Hicom 150 E Office Rel.1.0 Service Manual - 7.2 Features for general incoming traffic
Call forwarding - no answer
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step Action
1.
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1.
Performing Feature Check
Check the feature for error-free functioning as follows:
Step Action
1.
7.2.15 Leave UCD Group
Definition
An agent can temporarily leave the UCD group.
Direct calls for this agent which were not directed to the group continue to be signalled and put
through.
If necessary, the agent can send a message to any extension, e.g. a request for support.
Model-Specific Data
Subject
Feature available in
HW requirements
SW requirements
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_72.htm (24 of 48) [06/04/2000 13:09:58]
If an agent is called but does not answer the call, he automatically
switches to "unavailable" mode when call forwarding - no answer
takes place.
OfficePro
OfficeCom
x
-
As of Rel. 1.0 As of Rel. 1.0
OfficePoint OfficeOne
x
_
-
-
_
_
-
_