Call Duration Display On Terminal - Siemens Hicom 150 E Office Service Manual

Hicom 150 E Office Rel.1.0 Service Manual - 7.12 Features for Call Detail Recording
1. Configure call charges
System status
2. Call charges
3. Output format
Performing Feature Check
Check the feature for error-free functioning as follows:
Step
1. Conduct a chargeable call.
The charges for this call are displayed as per programming.

7.12.3 Call Duration Display on Terminal

Definition
A call duration display is provided for external calls (outgoing or incoming) when no call charge
information is available.
The starting point for call detail recording is set for analog lines by means of a timer (5 seconds after
end of dialling).
In the case of digital trunk lines, recording is started when the call is received (at "CONNECT").
Model-Specific Data
Subject
Feature available in
HW requirements
SW requirements
Dependencies/Limitations
Subject
S / CMI terminal In the S
0
Configuration options
This feature does not have to be explicitly configured.
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_712.htm (4 of 21) [06/04/2000 13:08:17]
Action
OfficePro
x
optiset E
terminal with
display
As of Rel. 1.0
and CMI terminals the call duration display is not supported by the
0
system.
OfficeCom
x
optiset E
terminal with
display
As of Rel. 1.0
Dependency/Limitation
OfficePoint
x
optiset E
terminal with
display
As of Rel. 1.0
OfficeOne
x
optiset E
terminal with
display
As of Rel. 1.0