Siemens Hicom 150 E Office Service Manual page 26

Hicom 150 E Office Rel.1.0 Service Manual - Tables
Table 3-27 TML8W - LED states
Table 3-28 TML8W - cable assignment
Table 3-29 TMOM - LED states
Table 3-30 TMOM - cable assignment
Table 3-31 TMS2 - SU connector assignment
Table 3-32 TMS2 - LED states
Table 3-33 TS2 contact assignment for symmetrical lines
Table 3-34 TS2 contact assignment for coaxial lines
Table 3-35 4SLA/8SLA contact assignments
Table 3-36 16SLA contact assignments
Table 3-37 ALUM4 contact assignments
Table 3-38 EXM contact assignments
Table 3-39 GEE12/16/50 modules
Table 3-40 GEE12/16/50 contact assignments
Table 3-41 MPPI contact assignments
Table 3-42 STRB current carrying capacity of the control relay outputs
Table 3-43 STRB contact assignments
Table 3-44 Pin assignment for 9-pin socket and 25-pin connector of the V.24 cable for
OfficePro
Table 3-45 Boards from Hicom 150 E Releases 1.0, 2.0, 2.1
Table 3-46 Boards from Hicom 100 E Releases 2.02, 2.1
Table 4-1 Hicom 150 E OfficePro - procedures for system installation
Table 4-2 Colour code for the open-end cable
Table 4-3 Socket assignments in the backplane
Table 4-4 Visual inspection procedures
Table 5-1 Hicom 150 E OfficePro - start-up procedure
Table 5-2 CBMOD - board status display
Table 5-3 CBMOD - status display for the integrated modem
Table 5-4 CBMOD - seven-segment display during the system boot
Table 5-5 Entering the country code
Table 5-6 Country codes
Table 5-7 Entering the route telephone number
Table 5-8 Start-up
Table 5-9 CBFC - board status display
Table 5-10 CBFC - status display for the integrated modem
Table 5-11 Entering the country code
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/h150_eha.htm (2 of 4) [06/04/2000 13:02:18]