Siemens Hicom 150 E Office Service Manual page 517

Hicom 150 E Office Rel.1.0 Service Manual - 7.8 Features for internal traffic
Performing Feature Check
Check the feature for error-free functioning as follows:
Step
1. Configure DSS key.
2. Press the DSS key. The programmed extension rings.
7.8.3 Names
Definition
Names can be assigned to each extension, to each extension group and to each route. These names are
displayed for internal calls (including CorNet-N). If an internal call does not contain extension
number information (e.g. analog CO), the relevant route name is displayed. If the incoming call
contains extension number information (ISDN), this information is displayed. See also
Extension Numbers to Names for System Speed-Dialling (on page
Model-Specific Data
Subject
Feature available in
HW requirements
SW requirements
Max. length of extension and group
names
Max. length of route names
Dependencies/Limitations
Subject Dependency/Limitation
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step
1. Configure extension names
*9531994
2. 14-12 => Extension Data Menu - Extension Name
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_78.htm (3 of 17) [06/04/2000 13:11:10]
Action
OfficePro
x
-
As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
16 letters
10 letters
Action
7-117).
OfficeCom OfficePoint
x
-
16 letters 16 letters
10 letters 10 letters
Translate
OfficeOne
x x
- -
16 letters
10 letters