Siemens Hicom 150 E Office Service Manual page 347

Hicom 150 E Office Rel.1.0 Service Manual - 7.12 Features for Call Detail Recording
Model-Specific Data
Subject
Feature available in
HW requirements
SW requirements
General requirements
No. stored calls
Dependencies/Limitations
Subject
PC/printer failure, buffer
full
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step
1. Configure CDRC
*9531994
2. 11-3-1 => Call detail record - Print Format - Full/Compressed
3. 11-3-2 => Call detail record - Print Format - Digit Suppression
4. 11-3-3 => Call detail record - Print Format - Incoming Calls
5. 11-3-4 => Call detail record - Print Format - Call Duration
6. 11-3-5 => Call detail record - Print Format - Print MSN
7. Configure port for CDRC
22-13- 2-1 => 1 to 3 System Options - Charges/System
8. Set baud rate
22-13-1 => System Options - MB Baud Rate
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_712.htm (12 of 21) [06/04/2000 13:08:18]
OfficePro OfficeCom
x
-
As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
Printer, Call charge computer
300
If the connected device fails, some data records are buffered in the
system and transmitted when the device is reactivated. If the buffer is
full, all additional data records are lost.
Action
OfficePoint
x x
- -
150 50
Dependency/Limitation
OfficeOne
x
-
50