Siemens Hicom 150 E Office Service Manual page 184

Hicom 150 E Office Rel.1.0 Service Manual - 6 Expanding the system
The printer must be turned off and on again in order for any changes to the settings made to
become effective.
The settings listed in the following table must be observed if using a different printer. Refer
to the operating instructions provided with the printer in question for more details.
Position of DIP switch series 1 and 2
Figure 6-5 P 500 printer - position of DIP switch series 1 and 2
DIP switch series 1
Table 6-2 P 500 printer - DIP switch series 1
Switch no.
1-1 International characters
1-2
1-3
1-4 1 Choice between EPSON and IBM mode
1-5 Character set selection in IBM mode
1-inch hole in EPSON mode
1-6 Page length
2 LF code selection in IBM mode
1-7
DC1/DC3 code selection in EPSON mode
3
CR code selection in IBM mode
1-8
CR code selection EPSON mode
The default settings are highlighted in bold.
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_6m.htm (10 of 14) [06/04/2000 13:05:06]
Function Switch setting
On Off
see Table 6-3
IBM EPSON
Char. set 2 Char. set 1
Yes No
12 inches 11 inches
LF+CR LF only
No Yes
CR+LF CR only
CR+LF