Call Keys - Siemens Hicom 150 E Office Service Manual

Hicom 150 E Office Rel.1.0 Service Manual - 7.4 Features for general external traffic
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step
1. Configure line key
*91 => Entry to key programming.
2. Press relevant key.
3. Assign `Line key' to selected key.
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Configure line key
Options
2. Set up station
3. Key programming
Performing Feature Check
Check the feature for error-free functioning as follows:
Step
1. Program key.
2. Press the line key.
3. You can place an outgoing call if a line is available.

7.4.4 Call Keys

Definition
You can program up to 10 call keys (together with MSN) on the optiset E terminal. These keys are
used for incoming and outgoing calls. The call keys are assigned to lines virtually, i.e. the lines are not
permanently assigned to a specific key (like route keys). When performing an outgoing external
seizure, you press the call key to seize the route assigned to it. When setting up a connection without a
call key, an available call key is automatically seized, regardless of which route is used. With
incoming calls, an available call key corresponding to the route is also assigned.
The call keys are temporary line keys. They enable you to use the following features:
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_74.htm (5 of 10) [06/04/2000 13:10:14]
Action
Action