Siemens Hicom 150 E Office Service Manual page 520

Hicom 150 E Office Rel.1.0 Service Manual - 7.8 Features for internal traffic
Opener: In this configuration, the door opener is set up via an a/b interface. In this case, the
entrance telephone must be connected via an adapter box.
DTMF: This setting determines whether the door opener is activated by a DTMF transmitter.
Call forwarding: This setting determines whether the call from the entrance telephone will be
forwarded to a forward by network destination from the destination extension.
Model-Specific Data
Subject
Feature available
in
HW requirements Entrance telephone
SW requirements
Max. number of
entrance
telephones
Dependencies/Limitations
Subject
Entrance telephone ring
destination
Night extension
OfficeOne
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step
1. Before setting up an entrance telephone, first delete all features for this extension.
2. *9531994
3. 24-1 => Doorphone Setup - Doorphone CM
4. 24-2 => Doorphone Setup - Doorbell CM
5. 24-3 => Doorphone Setup - Open door
6. 24-4 => Doorphone Setup - Doorphone forward
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_78.htm (6 of 17) [06/04/2000 13:11:10]
OfficePro
x
Entrance telephone
or ET/A or
ET+amplifier
As of Rel. 1.0
4
If a call is already indicating camp-on at the entrance telephone ring
destination, an intercept is performed. If the intercept extension is
also busy, the system is scanned for optiset E terminals.
Night extension is not taken into account for signalling.
Door busy/service call available via optiset E Control Adapter
OfficeCom
x
Entrance telephone
or ET/A or
ET+amplifier
As of Rel. 1.0
4
Dependency/Limitation
Action
OfficePoint
x
Entrance telephone
or ET/A or
ET+amplifier
As of Rel. 1.0
4
OfficeOne
x
or ET/A or
ET+amplifier
As of Rel. 1.0
1