Siemens Hicom 150 E Office Service Manual page 542

Hicom 150 E Office Rel.1.0 Service Manual - 7.11 Networking
Dependencies/Limitations
Subject
Buffer box
Call via the remote
system's main CO
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step
1. Configure charge factor
*9531994
2. 11-4 => Call detail record - Edit Charge Factor
3. Configure charge detail recording for ISDN
*9531994
4. 11-5 => Call detail record - ISDN Factor
5. Configure currency unit
*9531994
6. 11-6 => Call detail record - Currency Unit
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Configure charges
System status
2. Call charges
3. Output format
Performing Feature Check
Check the feature for error-free functioning as follows:
Step
1. Make a chargeable call. The charges for this call are displayed depending on the program.
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_711.htm (6 of 17) [06/04/2000 13:11:33]
If a PABX in the network has local access to trunks, a local buffer box can
be used for charges.
In the case of an outgoing call conducted from an extension in a system
via the remote system's main CO, the call charges incurred in the system
in which the trunk is seized, are output as call type 6 (outgoing
non-switched)!
Action
Dependency/Limitation
Action