Table 3-15 Slmc8 - Cable Assignment - Siemens Hicom 150 E Office Service Manual

Hicom 150 E Office Rel.1.0 Service Manual - 3.3 Peripheral boards
Off Off
On Off
Flashing Off
Off On
Off Flashing
Cable and SU connector assignment (backplane)

Table 3-15 SLMC8 - cable assignment

Colour Pair a-wire b-wire SU conn.
group
1 1 wht/blu
2 wht/ora
3 wht/grn
4 wht/brn
5 wht/gry
2 6 red/blu
7 red/ora
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_32.htm (6 of 46) [06/04/2000 13:03:52]
Board not receiving power / is not
plugged in correctly.
Board is deactivated.
Board is receiving power / board test in
progress.
Board is defective if state remains
unchanged (i.e. board test was
unsuccessful).
Error detected on board. Board is
deactivated (does not apply to errors
detected in test loops) / board was
deactivated by Hicom Assistant E.
Error detected on board. Board is
deactivated (does not apply to errors
detected in test loops) / board was
deactivated by Hicom Assistant E.
Loadware is being loaded.
Loading operation was successfully
completed / board is operational (idle
state).
At least one extension is activated.
BP: X8
19
blu/wht 39
38
ora/wht 48
27
grn/wht 47
16
brn/wht 46
05
gry/wht 45
14
blu/red 44
23
ora/red 43
SLMC8 Notes
1a Access 1 Base station 1
1b
2a Access 2 Base station 2
2b
3a Access 3 Base station 3
3b
4a Access 4 Base station 4
4b
5a Access 5 Base station 5
5b
6a Access 6 Base station 6
6b
7a Access 7 Base station 7
7b
Check plug contact on board.
Replace board.
Replace board.
Check whether board was
deactivated by Hicom Assistant
E. If not, replace board.