Expert Mode Codes - Siemens Hicom 150 E Office Service Manual

Hicom 150 E Office Rel.1.0 Service Manual - A System programming codes
Write to/check the caller list, saving a
call number
Replacement-code for #
Replacement-code for *
Attendant console (AC), internal
Internal call numbers - master:
a) OfficePoint
b) OfficePro/OfficeCom
Internal call numbers - slave:
a) OfficePoint
b) OfficePro/OfficeCom
Internal call number group:
a) OfficePoint
b) OfficePro/OfficeCom
Trunk code:
a) OfficePoint
b) OfficePro/OfficeCom
Trunk group code:
a) OfficePoint
b) OfficePro/OfficeCom
A = All terminals
D = Display (pushbutton telephone)
E = Entry, Basic
A.3 Expert mode codes
Introduction
Hicom 150 E Office systems can also be programmed with an optiset E memory in expert mode.
Expert mode is initiated by entering consecutive digit sequences. The system branches automatically
to the relevant option.
Error message displays
You must exit error messages! If you receive an error message after entering a code that is already
used, the expert code appears at the top of the second display row. This expert code can then be used
to jump to the relevant part of the menu.
Selecting with codes
Codes containing one or more digits, depending on the menu, must be entered. The keypad character
"*" can be used to change the data position, and "#" to activate the configuration point on the dialling
keypad.
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_a1.htm (4 of 18) [06/04/2000 13:07:13]
* 82
76
75
9
a) 11-30
b) 100-349
a) 51-70
b) 500-749
a) 31-50
b) 350-499
a) 801-816
b) 7801-7920
a) 0 / 82-88
b) 0 / 80-84
850-859
N = Normal telephone, TA from, TA RS232
S = S0 terminal, TA S0
# 82
C = Cordless
D
A
A
A
A
A
A
A
A