Features For Outgoing External Traffic; Last Number Redial (Lnr) - Siemens Hicom 150 E Office Service Manual

Hide thumbs Also See for Hicom 150 E Office:

Table of Contents

Hicom 150 E Office Rel.1.0 Service Manual - 7.6 Features for outgoing external traffic

7.6 Features for outgoing external traffic

Each time an outgoing call is set up, the extension number dialled is stored. If the call is not put

through, you can press the redial key to redial the same number and set up another call.

The system automatically redials the extension number that was last dialled from the subscriber

extension. This feature is usually implemented when a dialled number is busy or the extension does

Any speed-dialling numbers used overwrite the redial memory.

Model-Specific Data

Feature available in

HW requirements

SW requirements

Max. length of stored number

Dependencies/Limitations

DTMF signals are not regarded as dialling information and are therefore not stored.

You cannot use the redial feature if the code lock has been activated.

Internal calls Setting up internal calls has no effect on the redial

Configuration options

This feature does not have to be explicitly configured.

Performing Feature Check

Check the feature for error-free functioning as follows:

Set up an external connection.

Release the external connection.

http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_76.htm (1 of 21) [06/04/2000 13:10:45]

As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0

Dependency/Limitation

Table of Contents