Call Deflection (Cd) - Siemens Hicom 150 E Office Service Manual

Hicom 150 E Office Rel.1.0 Service Manual - 7.13 Euro-ISDN features
Call Forwarding No Reply CFNR
Same as CFU but only if the call is not answered within a specified period of time (15 seconds).
Model-Specific Data
Subject
Feature available in
HW requirements
SW requirements
CO feature
Extension feature
Dependencies/Limitations
Subject
CFW Not possible with an S
CFW In the case of a telecommunications port, forwarding applies to the entire port; with an
MDC port, only the MSN assigned to the extension with programming authorisation is
forwarded. If an MSN has not been assigned to this terminal, forwarding cannot be
activated.
CFW Forwarding is always performed for the first basic port, i.e. the first S
present in the system.
S internal Only CFU is supported for internal extensions as otherwise conflicts with call
0
management may occur.

7.13.9 Call Deflection (CD)

Definition
If an extension has activated forward by network, Hicom 150 E Office attempts to forward this call to
the CO using this feature. In this case, when the call is received the CO is informed of the new call
destination and the extension number of the forwarding extension. If external forwarding using call
deflection is not possible, the call is forwarded via the PABX.
Model-Specific Data
Subject
Feature available in
HW requirements
SW requirements
CO feature
Extension feature
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_713.htm (7 of 16) [06/04/2000 13:11:53]
OfficePro OfficeCom
x
S
0
As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
x
x
port
2M
OfficePro OfficeCom
x
S
0
As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
x
-
OfficePoint
x x
module
x x
x x
Dependency/Limitation
OfficePoint
x x
module
x x
- -
OfficeOne
x
-
x
x
port must also be
0
OfficeOne
x
-
x
-