Detecting The Signalling Method Of A/B Stations - Siemens Hicom 150 E Office Service Manual

Hicom 150 E Office Rel.1.0 Service Manual - 7.1 Features for all traffic types
Performing Feature Check
Check the feature for error-free functioning as follows:
Step
1. Set up a call.
2. Initiate an enquiry call.
3. Call another extension.
4. Perform an unscreened transfer.
5. Do not answer the call at the transferred extension. After the timer expires, the call should
return in the form of a recall.

7.1.11 Detecting the Signalling Method of a/b Stations

Definition
After the system has booted all analog subscriber ports are set to tone dialling. If an analog subscriber
port has to be switched to pulse dialling, both Hicom Assistant T and Hicom Assistant E can be used
to do this. The system need not be reset after the signalling method has been changed. The new
signalling method is operational immediately.
Model-Specific Data
Subject
Feature available in
HW requirements
SW requirements
Dependencies/Limitations
Subject
Signalling method If a DP signal is detected, the code receiver remains activated in order to avoid
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_71.htm (12 of 18) [06/04/2000 13:09:16]
OfficePro OfficeCom
x
-
As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
circumvention of the toll restriction facility.
Action
Action
OfficePoint
x x
- -
Dependency/Limitation
OfficeOne
x
-