Closed Numbering - Siemens Hicom 150 E Office Service Manual

Hicom 150 E Office Rel.1.0 Service Manual - 7.11 Networking

7.11.2 Closed Numbering

Definition
In private networks, extension numbers, trunk access codes and codes for features can be assigned in
accordance with a numbering plan stipulated by the customer.
Hicom 150 E Office supports closed and open numbering. When the extension numbers are unique
throughout the network, each subscriber in the network can call another extension by dialling the
relevant extension number. This is referred to as a closed numbering plan.
CorNet N dial plans support extension numbering. In the CorNet N network private extension
numbers of not more than 6 digits in length can be assigned uniquely. This type of numbering is also
referred to as closed numbering.
Model-Specific Data
Subject
Feature available in
HW requirements
SW requirements
Dependencies/Limitations
Subject
Numbering Internal numbering can only be changed using Assistant E.
Configuration options
The feature can be configured using:
Hicom Assistant E
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
1. Options
2. Set up station
3. Station
4. Least cost routing
Performing Feature Check
Check the feature for error-free functioning as follows:
Step
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_711.htm (3 of 17) [06/04/2000 13:11:33]
OfficePro OfficeCom
x
-
As of Rel. 1.0 As of Rel. 1.0
Dependency/Limitation
Action
OfficePoint OfficeOne
x _
- -
_
_
-
_