Selecting The Installation Site - Siemens Hicom 150 E Office Service Manual

Hicom 150 E Office Rel.1.0 Service Manual -
Figure 4-30 OfficeOne system overview

4.2.4 Selecting the installation site

Selecting the installation site
The installation site is generally determined in advance upon approval by the customer.
The following requirements must be observed when selecting the site of installation:
Do not expose the system to direct sources of heat (such as sunlight, heaters, etc.).
Do not expose the system to extremely dusty environments.
Avoid contact with chemicals.
Take every precaution to prevent the formation of condensation on the system during operation.
Systems on which condensation has formed must be dried before start-up.
The environmental conditions specified in the chapter on system data
be observed.
Note
Information on the design of the system can be found in the following sections:
Hicom 150 E OfficeCom
Hicom 150 E OfficePoint
Hicom 150 E OfficeOne
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_4fc.htm (7 of 9) [06/04/2000 13:04:51]
Section 2.3.2,
Section 2.3.3,
Section 2.3.4.
(Section 2.7.3) are also to