Siemens Hicom 150 E Office Service Manual page 460

Hicom 150 E Office Rel.1.0 Service Manual - 7.4 Features for general external traffic
Routes
No. of route keys on
optiset E
Dependencies/Limitations
Subject
Analog trunk lines
Prime Line
optiset E, route key Up to 10 route keys can be programmed on the optiset E terminal. If all lines in
Overflow
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step
1. Assign routes
*9531994
2. 17-11 => Call Management Out - Simplified Dialling
3. 17-12 => Call Management Out - Route Assignment
4. 17-13 => Call Management Out - Route Overflow
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step
1. Assign routes
Options
2. Lines / networking
3. Trunks + Routes + Routing parameters
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_74.htm (3 of 10) [06/04/2000 13:10:14]
16 routes with
max. 72 B
channels per
route
6
Physically disconnected analog trunk lines (loop start) must be removed from
the route.
In the case of Prime Line on, all lines must be programmed in route 1. Prim
Line must be deactivated before another route is entered.
a route are busy, the appropriate route lights up.
If a route is busy and an overflow for this route has been entered in the system,
an overflow to the overflow route takes place. No further overflow operation is
performed if all lines in this route are also busy.
Action
Action
16 routes (line 8 routes with max.
groups), 64 B all B channels per
channels
6
Dependency/Limitation
8 routes with
max. all B
route channels per route
6 6