Group Call With Busy Signalling - Siemens Hicom 150 E Office Service Manual

Hicom 150 E Office Rel.1.0 Service Manual - 7.2 Features for general incoming traffic

7.2.8 Group Call with Busy Signalling

Definition
If a group member is busy, incoming calls to this group receive a busy signal. The call also camps on
at the busy extension.
Model-Specific Data
Subject
Feature available in
HW requirements
SW requirements
Groups/extensions
Dependencies/Limitations
Subject
Camp-on rejection
Direct inward dialling If an extension in the group is called directly, the call is signalled at the
Group
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step
1. Configure group call
*9531994
2. 16-15-1 => Call Management Inc - Group Setup - Group Members
3. 16-15-2 => Call Management Inc - Group Setup - Group Type
4. 16-15-3 => Call Management Inc - Group Setup - Group Name
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step Action
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_72.htm (15 of 48) [06/04/2000 13:09:58]
OfficePro OfficeCom
x
-
As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
150/20 150/20
The call does not camp on if the busy extension has activated camp-on
rejection.
called extension.
If an optiset E terminal in the group is defective, the group is handled as
though it were busy.
Action
OfficePoint
x x
- -
20/8
Dependency/Limitation
OfficeOne
x
-
20/8