Ptp On The User Side; Setting National And International Codes For Outgoing Calls - Siemens Hicom 150 E Office Service Manual

Hicom 150 E Office Rel.1.0 Service Manual - 7.13 Euro-ISDN features
CO feature
Extension feature
Dependencies/Limitations
Subject Dependency/Limitation

7.13.19 PtP on the User Side

Definition
It is possible to configure an S
able to use a connected fax server. The port receives an extension number with which a DID is
enabled. Call forwarding can also be configured on this port.
Model-Specific Data
Subject
Feature available in
HW requirements
SW requirements
CO feature
Extension feature
Dependencies/Limitations
Subject
PtP Only the DID, CLIP, CLIR and AOC features are supported.

7.13.20 Setting National and International Codes for Outgoing Calls

Definition
The caller`s extension number is shown in the display of optiset E terminals, in the missed calls list
and in dialling aids (e. g. Smartset) depending on the origin including the trunk access code (e. g."0"),
the national (e. g. "0") or international (e. g. "00") prefix.
In general, carriers are contacted via an individual national (1-digit) and international (2-digit) prefix.
If a Hicom 150 E Office system has access to several carriers (individual port or shared port), it is not
possible to identify the carrier from which the call is originating in the case of incoming calls.
This feature makes it possible to configure national and international access codes (national and
international prefix) to enable the display of a prefix. The values of the codes that can be configured
range between "0"and "9".
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_713.htm (14 of 16) [06/04/2000 13:11:54]
-
x
port on the user side as a point-to-point connection, e.g. in order to be
0
OfficePro OfficeCom
x
S
0
As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
-
x
Dependency/Limitation
- -
x x
OfficePoint
x x
module
- -
x x
-
x
OfficeOne
x
-
-
x