Dtmf Transmission During A Call - Siemens Hicom 150 E Office Service Manual

Hicom 150 E Office Rel.1.0 Service Manual - 7.3 Features for general outgoing traffic
7.3 Features for general outgoing traffic

7.3.1 DTMF Transmission During a Call

Definition
You can activate the "DTMF transmission" feature while engaged in an internal or external call by
pressing a key or entering a code. From this point on, all keystrokes from the dialling keypad are
transmitted in the form of DTMF digits. If a call is placed to a port configured for voice mail from an
optiset E terminal, the connection automatically switches over to DTMF mode once it has been set up.
Alternatively, you can automatically switch over to DTMF mode after each successful connection
setup (even with CMI). The feature is configured system-wide (automatic DTMF).
Activating the transfer, enquiry, shuttle and call pickup features as well as answering a camped-on
call deactivates DTMF mode.
The DTMF characteristic (pulse/pause) can be configured in the system.
Model-Specific Data
Subject
Feature available in
HW requirements
SW requirements
Dependencies/Limitations
Subject
DP extension
Extension on hold
Conference, park, recall
Other features during DTMF When DTMF mode is active, you must always use the "S" key
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_73.htm (1 of 6) [06/04/2000 13:10:06]
OfficePro OfficeCom
x
-
As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0 As of Rel. 1.0
DP extensions cannot use this feature.
An extension on hold cannot transmit any DTMF signals.
DTMF transmission cannot take place during a conference, recall or in
"park" mode.
(Service) to activate features during the call.
OfficePoint
x x
- -
Dependency/Limitation
OfficeOne
_
-