Extension Speed-Dialling In System - Siemens Hicom 150 E Office Service Manual

Hicom 150 E Office Rel.1.0 Service Manual - 7.6 Features for outgoing external traffic

7.6.4 Extension Speed-Dialling in System

Definition
The user can create a separate speed-dialling list for frequently dialled numbers.
External numbers can be programmed in the database. Access is determined by the extension`s
dialling privileges. The route code must be entered prior to dialling the phone number.
Model-Specific Data
Subject
Feature available in
HW requirements
SW requirements
Max. extension
speed-dialling entries per
extension
Max. length of extension
speed-dialling entry
Max. no. of extension
speed-dialling entries in the
system
Dependencies/Limitations
Subject
Terminals without display
Analog terminals (with DP),
S terminals
0
Internal extension numbers,
features
optiset E
Repdial keys,
extension speed-dialling memory
Configuration options
This feature does not have to be explicitly configured.
Performing Feature Check
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_76.htm (5 of 21) [06/04/2000 13:10:45]
OfficePro
x
-
As of Rel. 1.0
10
25 Digits + Code 25 Digits+ Code 25 Digits+ Code 25 Digits+ Code
2000
Following extension number entry, terminals without a display
must wait or the confirmation tone.
Extension speed-dialling is not possible
Internal extension numbers and features cannot be stored.
In the case of optiset E terminals, extension speed-dialling can
be stored under ten codes or under the terminal`s programmable
keys.
Extension speed-dialling destinations can continue to be
assigned until the extension speed-dialling memory in the
system has been exhausted. The memory is used for both repdial
keys and extension speed-dialling destinations.
OfficeCom OfficePoint
x
-
As of Rel. 1.0 As of Rel. 1.0
10
2000
Dependency/Limitation
OfficeOne
x x
- -
As of Rel. 1.0
10 10
300 300