Call Detail Recording Central (Cdrc) - Siemens Hicom 150 E Office Service Manual

Hicom 150 E Office Rel.1.0 Service Manual - 7.12 Features for Call Detail Recording
ENB
Conference
Configuration options
The feature can be configured using:
Hicom Assistant T / Hicom Assistant E
Programming Feature Via Hicom Assistant T
Configure the feature via Hicom Assistant T as follows:
Step
1. Configure project code
*9531994
2. 13-1 => Project Code - Code entries
3. 13-2 => Project Code - Verification mode
4. 13-3 => Project Code - Trunk group mode
5. 13-4 => Project Code - Code length
Programming Feature Via Hicom Assistant E
Configure the feature via Hicom Assistant E as follows:
Step
1. Configure project codes, System status
2. Call charges
3. Project codes
Performing Feature Check
Check the feature for error-free functioning as follows:
Step
1. Configure `Mandatory project code'
2. The trunk line can only be seized when the project code has been entered.

7.12.8 Call Detail Recording Central (CDRC)

Definition
During Hicom 150 E Office operation, the CDRC call data can be transmitted consecutively via the
V.24 interface for each call segment terminated or for each incoming call to the connected device.
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_712.htm (10 of 21) [06/04/2000 13:08:18]
In the ENB, "project code+number", but not "number+project
code" can be programmed as an entry.
A project code entered during a conference with external
subscribers is assigned to all participating calls/lines.
Action
Action
Action