Setting Basic Switch Properties
Table 3-2 Optional CLI Setup Commands
Task
Save the active configuration.
Enable or disable SSH.
Enable or disable Telnet.
Enable or disable HTTP
management (WebView).
Enable or disable SNMP port link
traps.
Set the per port broadcast limit
Configure a VLAN.
Set a Syslog server IP and
severity
Configure and enable a RADIUS
server.
Setting Basic Switch Properties
Purpose
To display and set the system IP address and other basic system (switch) properties.
Commands
For information about...
show ip address
set ip address
clear ip address
show ip protocol
set ip protocol
show ip route
show system
show system hardware
show system utilization
set system utilization
clear system utilization
show system enhancedbuffermode
set system enhancedbuffermode
3-2 Basic Configuration
CLI commands
save config
set ssh enable | disable
set telnet {enable | disable} [inbound |
outbound | all]
set webview {enable | disable}
set port trap port-string {enable | disable}
set port broadcast port-string threshold-value
set vlan create vlan-id
set port vlan port-string vlan-id modify-egress
set logging server index ip-addr ip-addr
severity severity state enable
set radius server index ip-addr
port [secret-value]{realm {management-access |
any | network-access}
set radius enable
Refer to
page...
3-37
32-89
3-33
3-51
11-24
11-35
14-5
14-9
19-4
32-8
32-8
Refer to page...
3-3
3-4
3-5
3-5
3-6
3-6
3-7
3-8
3-9
3-10
3-11
3-11
3-12