Clear Spantree Fwddelay; Show Spantree Backuproot - Enterasys D-Series Cli Reference Manual

clear spantree fwddelay

Use this command to reset the Spanning Tree forward delay to the default setting of 15 seconds.
Syntax
clear spantree fwddelay
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to globally reset the bridge forward delay:
D2(su)->clear spantree fwddelay

show spantree backuproot

Use this command to display the backup root status for an MST instance.
Syntax
show spantree backuproot [sid]
Parameters
sid
Defaults
If a SID is not specified, then status will be shown for Spanning Tree instance 0.
Mode
Switch command, read‐only.
Example
This example shows how to display the status of the backup root function on SID 0:
D2(rw)->show spantree backuproot
Backup root is set to disable on sid 0
(Optional) Display backup root status for a specific Spanning Tree
identifier. Valid values are 0 ‐ 4094. If not specified, SID 0 is assumed.
clear spantree fwddelay
Enterasys D-Series CLI Reference 8-21