Downloading From A Tftp Server; Downloading Via The Serial Port - Enterasys D-Series Cli Reference Manual

Downloading from a TFTP Server

To perform a TFTP download, proceed as follows:
1. If you have not already done so, set the switch's IP address using the set ip address command
as detailed in "set ip address" on page 2‐10.
2. Download a new image file using the copy command as detailed in "copy" on page 2‐40.

Downloading via the Serial Port

To download switch firmware via the serial (console) port, proceed as follows:
1. With the console port connected, power up the switch. The following message displays:
Version 01.00.29 05-09-2005
Computing MD5 Checksum of operational code...
Select an option. If no selection in 2 seconds then
operational code will start.
1 - Start operational code.
2 - Start Boot Menu.
Select (1, 2):2
Password: *************
2. Before the boot up completes, type 2 to select "Start Boot Menu". Use "administrator" for
the Password.
Note: The "Boot Menu" password "administrator" can be changed using boot menu option 11.
Boot Menu Version 01.00.29 05-09-2005
Options available
1 - Start operational code
2 - Change baud rate
3 - Retrieve event log using XMODEM (64KB).
4 - Load new operational code using XMODEM
5 - Display operational code vital product data
6 - Run Flash Diagnostics
7 - Update Boot Code
8 - Delete operational code
9 - Reset the system
10 - Restore Configuration to factory defaults (delete config files)
11 - Set new Boot Code password
[Boot Menu] 2
3. Type 2. The following baud rate selection screen displays:
1 - 1200
2 - 2400
3 - 4800
4 - 9600
5 - 19200
6 - 38400
Downloading a Firmware Image
Enterasys D-Series CLI Reference 2-29