Table of Contents
Advertisement
Registers
Table 10-18. Audio Mute Control Register (AMUTE) Field Descriptions (continued)
Bit
Field
Value
5
ROVRN
0
1
4
INSTAT
0
1
3
INEN
0
1
2
INPOL
0
1
1-0
MUTEN
0-3h
0
1h
2h
3h
1086
Multichannel Audio Serial Port (McASP)
Preliminary
Description
If receiver overrun error (ROVRN), drive AMUTE active enable bit.
Drive is disabled. Detection of receiver overrun error is ignored by AMUTE.
Drive is enabled (active). Upon detection of receiver overrun error, AMUTE is active and is driven
according to MUTEN bit.
Determines drive on AXRn pin when PFUNC[n] and PDIR[n] bits are set to 1.
AMUTEIN pin is inactive.
AMUTEIN pin is active. Audio mute in error is detected.
Drive AMUTE active when AMUTEIN error is active (INSTAT = 1).
Drive is disabled. AMUTEIN is ignored by AMUTE.
Drive is enabled (active). INSTAT = 1 drives AMUTE active.
Audio mute in (AMUTEIN) polarity select bit.
Polarity is active high. A high on AMUTEIN sets INSTAT to 1.
Polarity is active low. A low on AM UTEIN sets INSTAT to 1.
AMUTE pin enable bit (unless overridden by GPIO registers).
AMUTE pin is disabled, pin goes to tri-state condition.
AMUTE pin is driven high if error is detected.
AMUTE pin is driven low if error is detected.
Reserved
© 2011, Texas Instruments Incorporated
www.ti.com
SPRUGX9 – 15 April 2011
Submit Documentation Feedback
Advertisement
Table of Contents
