Table of Contents
Advertisement
r . l J
Valve Clearance
Adjustment
NOTE:
. V a l v e s s h o u l d b e a d j u s t e d c o l d ; a t a c y l i n d e r h e a d
temperature of less than 100'F (38"C).
Adjustment is the same for both intake and exhaust
valves.
. After adjusting, retorque the crankshaft pulley bolt to
177 N.m (18.0 kgf.m, 130 lbf'ft).
1. Remove cylinder head cover.
ADJUSTING SCREW LOCATIONS:
EXHAUST
(
"UP" MARKS
TDC GBOOVES
2.
Set the No. 1 piston at top dead center (TDC) (see
p a g e 6 - 1 2 ) . " U P " m a r k o n t h e p u l l e y s h o u l d b e a t
the top, and the TDC grooves on the pulley should
a l i g n w i t h t h e T D C g r o o v e o n t i m i n g b e l t b a c k
cover. TDC mark (painted white) on the crankshaft
pulley should align with pointer on the timing belt
lower cover.
Number 1 piston at TDC:
POINTER ON
LOWER
TDC MAFK
(P.inted whh.l
(cont'd)
6-3
Advertisement
Table of Contents
Troubleshooting
