Table of Contents
Advertisement
-1,
Timing Belt
lllustrated lndex
NOTE:
.
Refer to page 6-12 for positioning crankshaft and pulley before installing belt.
. Mark the direction of rotation on the beh before removing.
. Replace the rubber seals if there is oil leakage between the cylinder head and cover.
. Do not use the middle cover and lower cover for storing removed items.
. Clean the middle cover and lower cover before installation.
CAP NUT
6 x 1 . 0 m m
9.8 N.m {'1.0 kgi.m,
WASHER
Replace when damaged
or deteriorated.
CYLINDER HEAD COVER
Refer to page 6-33 when
installing.
RUBBER SEALS
7.2 tbftll
TIMING BELT
Inspection, page 6 9
Adjustment, page 6 9
Replacement, page 6,10
B e p l a c e w h e n d a m a g e d
o r d e t e r i o r a t e d ,
8 x 1.25 mm
37 N.m (3.8 kgf.m, 27 lbf.ft)
BACK COVER
I n s t a l l w i t h c o n c a v e
s u r f a c e f a c i n g o u t .
R e m o v e a n y o i l
a n d c l e a n ,
ADJUSTING BOLT
10 x 1.25 mm
54 N.m {5.5 kgt.m, 40 lbf.ltl
MIDDLE COV€R
!
6 x 1 . 0 m m
9.8 N.m {1.0 kgf.m,
7.2lbl.ftl
6 x 1 . 0 m m
9.8 N.m 11.0 kgl.m, 7.2lbf.ftl
TIMING BELT
DRIVE PULLEY
Remove any oil
ano ctean.
LOWER
COVER
CRANKSHAFT
PULLEY
Remove any oil
and clean the
timing belt guide
plate side.
6 x 1 . 0 m m
'11 N.m (1.1 kgf.m,
8.0 lbI.ft)
SPEED
ItEi:lufrroN
{cKF)
NOTE: When installing a new crankshaft and/or new bolt:
O tighten the crankshaft pulley bott to 196 N.m (20.0 kgf.m, 145 tbf.ft),
@ loosen bolt,
@ retighten it to 177 N.m (18.0 kgnm, 130 tbnft).
PULLEY EOLT
14 x 1.25 mm
177 N.m (18.0 kgf.m, 130 bnftl
Replacement, page 6-8
6-7
Advertisement
Table of Contents
Troubleshooting
