Gylinder Head
Removal (cont'dl
Remove the fuel return hose and positive crankcase
ventilation (PCV) hose.
R e m o v e t h e b r a k e b o o s t e r v a c u u m h o s e , w a t e r
bypass hose and vacuum hose.
ltosE
VACUUM HOSE
6 - 1 8
1 0 .
9 .
1 1 .
Remove the throttle cable,
Remove the throttle control cable (automatic trans-
mission only).
NOTE:
. Take care not to bend the cable when removing
it. Always replace any kinked cable with a new
one.
. A d j u s t t h e t h r o t t l e c a b l e a n d t h r o t t l e c o n t r o l
cable when installing (s€e section 11 and 14).
THROTTLE CONTROL
CABLE
ADJUSTING NUT
Remove the engine wire harness connectors and
wire harness clamps f.om the cylinder head and the
intake manifold.
Four fuel injector connectors
Intake air temperature (lATl sensor connector
E n g i n e c o o l a n t t e m p e r a t u r e { E C T ) s e n s o r c o n ,
nector
TDC/CKP/CYP sensor connector
lgnition coil connector
ECT gauge sending unit connector
Throttle position (TP) sensor connector
Manifold absolute pressure (MAP) sensor con-
necto r
ldle air control (lAC) valve connector
EVAP purge control solenoid valve connector
Crankshaft speed fluctuation (CKF) sensor con-
nector
a
a
a
a
a
a
a
a
ADJUSTING