AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 95

Programming Procedures
System Programming Position Assignment
Use this procedure to reassign the station jack used for system programming.
This jack should not be the same jack used for the operator position.
The system programming position can be reassigned only to one of the first five
jacks on the first MLX module. Only one system programming console is
allowed per system.
If you are programming on the console:
The console must be connected to the station jack currently assigned for
system programming.
As soon as you change the system programming jack, the system
programming session is terminated. To proceed with system
programming, you must connect the system programming console to the
newly assigned station jack and re-enter system programming.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[ F5 ]
press on the PC before saving your entry or menu selection,
Summary: System Programming Position Assignment
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
3-4 System Programming Position Assignment
Sys Program
[ F1 ]
press any key
System manager
All
Not required
Form 1, System Planning
First jack on first MLX module (also set as an operator
position)
Extension number of one of the first five jacks on the
first MLX module
No
No
System SProg Port
E n t e r E x i t
[ F1 ] [ F2 ] [ Alt ]
[ F5 ]
Exit
[ F5 ]
Drop Dial ext. no.
[ P ]
+ Dial ext. no.
[ F10 ]