AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 181

Programming Procedures
Display/Instruction
Step
.
For a single line/trunk, do the
6a
following:
1. Specify entry mode.
2. Specify the trunk number Dial [nnn].
for the pool.
Assign or remove trunk
3.
from the pool.
6b For a block of lines/trunks, do
the following:
1. Select the trunks
associated with the 20
line buttons on the
system programming
console.
2. Assign the appropriate
trunks to the pool.
The red LED indicates the
following:
on = trunk is assigned to
pool specified
off = trunk is not assigned
to pool specified
3. Save your entry
7 To return to System
Programming menu
3-90 Trunks to Pools Assignment
On the console
Select Entry Mode
Select Enter or
Delete.
Select Lines 01-20,
Lines 21-40,
Lines 41–60,
or Lines 61–80.
Toggle the LED On/Off,
as required.
Select Enter.
Select Exit two times.
On the PC
[F6]
Press
Type [nnn]
[F10] [F8]
Press or
[F1], [F2],
Press
[F3], [F4].
or
Toggle the letter R
On/Off, as required.
[F10]
Press
[F5]
Press two times.