AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 156

Programming Procedures
Toll Type
Use this procedure to specify whether users have to dial a toll prefix (1 or 0
before dialing an area code and telephone number. (Your local telephone
company should verify toll prefix requirements for each trunk. )
This setting is used by the system to classify calls as local or long distance so
that toll restrictions can be applied as appropriate.
NOTE:
This option applies only to loop- and ground-start trunks; it does not apply
to tie trunks or DID trunks.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[F5]
press on the PC before saving your entry or menu selection.
Summary: Toll Type
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
Entry mode available
†
Sys Program
[F1]
press any key
System manager
All
Not required
Form 2c, System Numbering - Trunk Jacks
Toll prefix required
Required, not required
N o
Yes
†
To program a single telephone:
Lines Trunks Toll Type
Dial no. Of the line
To program a block of telephones:
LinesTrunks Toll Type
Toggle LED On/Off
Exit
[F5]
select entry mode
Enter Exit Exit
Select block of lines
Enter Exit
Toll Type
Exit
3-65