AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 282

Programming Procedures
Incoming Routing
Use this procedure to specify whether incoming routing is by line appearance
or according to dial plan. Dial Plan Routing is available in Hybrid/PBX mode
only.
Entering Programming
Console: Select Menu
PC/SPM: Type SPM
Exiting Without Changes
To exit from any screen without making changes, select Exit on the console or
[F5]
press on the PC before saving your entry or menu selection.
Summary: Incoming Routing
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Sys Program
Exit
[F1]
press any key
Line appearance - All; Dial Plan Routing - Hybrid/PBX
only
Not required
Form 3b, Incoming Trunks - DS1 Connectivity (100D
Module)
Line appearance
Dial Plan Routing, Routing by Line Appearance
No
No
Lines Trunks PRI
Rtg Dial B-channel group no.
method of routing
[F4] [F6] [F2]
[F10]
no. Specify method of routing
[F5] [F5] [F5]
[F5]
B–ChannlGrp Incoming
Enter Specify
Enter Exit Exit
[F6]
Type B-channel group
[F10]
Incoming Routing
Exit
3-191